Scramble input signal
The Scrambler block scrambles a scalar or column vector input signal. If you set the Calculation base parameter to N, then the input values must be integers between 0 and N-1.
One purpose of scrambling is to reduce the length of strings of 0s or 1s in a transmitted signal, since a long string of 0s or 1s may cause transmission synchronization problems. Below is a schematic of the scrambler. All adders perform addition modulo N.
At each time step, the input causes the contents of the registers to shift sequentially. The Scramble polynomial parameter defines if each switch in the scrambler is on or off. Specify the polynomial by listing its coefficients in order of ascending powers of z-1, where p(z-1) = 1 + p1z-1 + p2z-2+..., or by listing the powers of z that appear in the polynomial with a coefficient of 1. For example p = [1 0 0 0 0 0 1 0 1] and p = [0 -6 -8] both represent the polynomial p(z-1) = 1 + z-6 + z-8.
The Initial states parameter lists the states of the scrambler's registers when the simulation starts. The elements of this vector must be integers between 0 and N-1. The vector length of this parameter must equal the order of the scramble polynomial. (If the Scramble polynomial parameter is a vector that lists the coefficients in order, then the order of the scramble polynomial is one less than the vector length). There is an optional port that can be used to reset the scrambler.
Alternatively, the initial states can be provided by an input port when Initial states source parameter is set to Input port.
This block can accept input sequences that vary in length during simulation. For more information about sequences that vary in length, or variable-size signals, see Variable-Size Signal Basics in the Simulink® documentation.
The calculation base N. The input and output of this block are integers in the range [0, N-1].
A polynomial that defines the connections in the scrambler.
A drop down menu that controls the source of the initial states. Select either Dialog Parameter or Input port. The default value is Dialog Parameter.
The states of the scrambler's registers when the simulation starts. This parameter is available when Initial states source is set to Dialog Parameter.
A check box that creates a reset port. When checked, the scrambler is reset if a nonzero input is applied to the port. This control is available when Initial states source is set to Dialog Parameter. The default is that the box is not checked.