Buffer input signal
Buffer object buffers an input signal.
The number of samples per channel in the input must equal the difference
between the output buffer size and buffer overlap (i.e.,
To buffer an input signal:
a buffer System object,
HBUFF, used to buffer
input signals with overlap.
a buffer object,
H, with each specified property
set to the specified value.
a buffer object,
ICS and other specified properties set to
the specified values.
Number of samples to buffer
Specify the number of consecutive samples from each input channel
to buffer. You can set this property to any scalar integer greater
Amount of overlap between outputs
Specify the number of samples by which consecutive output frames
overlap. You can set this property to any scalar integer greater
than or equal to
Specify the value of the object's initial output for cases of
nonzero latency as a scalar, vector, or matrix. The default is
|clone||Create instance of an object with the same property values|
|getNumInputs||Number of expected inputs to step method|
|getNumOutputs||Number of outputs of step method|
|isLocked||Locked status for input attributes and nontunable properties|
|release||Allow property value and input characteristics changes|
|reset||Reset the internal states of a System object|
|step||Buffer input signal based on past values|
Create a buffer of 256 samples with 128 sample overlap:
hreader=dsp.SignalSource(randn(1024,1),128); hbuff=dsp.Buffer(256,128); for i=1:8 y=step(hbuff,step(hreader)); % y is of length 256 with 128 samples % from previous input end
This object implements the algorithm, inputs, and outputs described on the Buffer block reference page. The object properties correspond to the block properties, except as noted.