Main Content

Supported Symbols in Actions

Boolean Symbols, true and false

Use the symbols true and false to represent Boolean constants. You can use these symbols as scalars in expressions. Examples include:

cooling_fan = true;
heating_fan = false;

Tip

These symbols are case-sensitive. Therefore, TRUE and FALSE are not Boolean symbols.

Do not use true and false in the following cases. Otherwise, error messages appear.

Note

If you define true and false as Stateflow® data objects, your custom definitions of true and false override the built-in Boolean constants.

Comment Symbols, %, //, /*

Use the symbols %, //, and /* to represent comments as shown in these examples:

% MATLAB comment line
// C++ comment line
/* C comment line */

You can also include comments in generated code for an embedded target (see Model Configuration Parameters: Comments (Simulink Coder). C chart comments in generated code use multibyte character code. Therefore, you can have code comments with characters for non-English alphabets, such as Japanese Kanji characters.

Hexadecimal Notation Symbols, 0xFF

C charts support C style hexadecimal notation, for example, 0xFF. You can use hexadecimal values wherever you can use decimal values.

Infinity Symbol, inf

Use the MATLAB® symbol inf to represent infinity in C charts. Calculations like n/0, where n is any nonzero real value, result in inf.

Note

If you define inf as a Stateflow data object, your custom definition of inf overrides the built-in value.

Line Continuation Symbol, ...

Use the characters ... at the end of a line to indicate that the expression continues on the next line. For example, you can use the line continuation symbol in a state action:

entry: total1 = 0, total2 = 0, ...
  total3 = 0;

MATLAB Display Symbol, ;

Omitting the semicolon after an expression displays the results of the expression in the Diagnostic Viewer. If you use a semicolon, the results do not appear.

Single-Precision Floating-Point Number Symbol, F

Use a trailing F to specify single-precision floating-point numbers in C charts. For example, you can use the action statement x = 4.56F; to specify a single-precision constant with the value 4.56. If a trailing F does not appear with a number, double precision applies.

Time Symbol, t

Use the letter t to represent absolute time that the chart inherits from a Simulink® signal in simulation targets. For example, the condition [t - On_time > Duration] specifies that the condition is true if the difference between the simulation time t and On_time is greater than the value of Duration.

The letter t has no meaning for nonsimulation targets, since t depends on the specific application and target hardware.

Note

If you define t as a Stateflow data object, your custom definition of t overrides the built-in value.