Modeling the United States Economy
Illustrates the use of a vector error-correction (VEC) model as a linear alternative to the Smets-Wouters Dynamic Stochastic General Equilibrium (DSGE) macroeconomic model, and applies many of the techniques of Smets-Wouters to the description of the United States economy.
Introduction to MIMO Systems
Multiple-Input-Multiple-Output (MIMO) systems, which use multiple antennas at the transmitter and receiver ends of a wireless communication system. MIMO systems are increasingly being adopted in communication systems for the potential gains in capacity they realize when using multiple antennas. Multiple antennas use the spatial dimension in
Perform basic peak analysis. It will help you answer questions such as: How do I find peaks in my signal? How do I measure distance between peaks? How do I measure the amplitude of peaks of a signal which is affected by a trend? How do I find peaks in a noisy signal? How do I find local minima?
Modeling an Automatic Transmission Controller
Model an automotive drivetrain with Simulink®. Stateflow® enhances the Simulink model with its representation of the transmission control logic. Simulink provides a powerful
Removing High-Frequency Noise from an ECG Signal
Lowpass filter an ECG signal that contains high frequency noise.
CoMP Dynamic Point Selection with Multiple CSI Processes
How multiple Channel State Information (CSI) processes provide the network with feedback for Coordinated Multipoint (CoMP) operation. In this example User Equipment (UE) data is
Filter a sinusoid with the Overlap-Add and Overlap-Save FFT methods using the Frequency-Domain FIR filter block.
Bedmachine_data loads data from Morlighem et al.'s BedMachine datasets.
Bedmachine_interp loads data from Morlighem et al.'s BedMachine datasets.
Bedmachine_profile plots a 2D profile of ice, water, and rock elevations along any path in Greenland or Antarctica. The data are from Morlighem et al.'s BedMachine datasets.
Arctic Mapping Examples
This file shows a few examples of how to use Arctic Mapping Tools for Matlab.
Calling Shared Libraries from Simulink
This paper discusses several approaches for calling shared libraries from Simulink models.
2-D and 3-D Plots
To create two-dimensional line plots, use the plot function. For example, plot the value of the sine function from 0 to 2\pi :
Designing a High Angle of Attack Pitch Mode Control
Use the Control System Toolbox™ and Simulink® Control Design™ to interact with Simulink to design a digital pitch control for the aircraft. In this example, we will design the controller to
Air Traffic Control Radar Design
Model a conceptual air traffic control (ATC) radar simulation based on the radar range equation.
Simulating Automatic Climate Control Systems
Simulate the working of an automatic climate control system in a car using Simulink® and Stateflow®. You can enter a temperature value you would like the air in the car to reach by double
Radar Tracking Using MATLAB Function Block
Use an extended Kalman filter with the MATLAB® Function block in Simulink® to estimate an aircraft's position from radar measurements. The filter implementation is found in the MATLAB