Hardware Support

NI myDAQ Support from MATLAB

Low cost data acquisition platform for measuring and analyzing signals.


MATLAB supports National Instruments myDAQ (NI myDAQ) hardware, a low-cost, portable USB DAQ device. NI myDAQ hardware is used for project-based learning and hands-on experimentation for analog circuits, sensors, signals, and systems.

Support for NI myDAQ hardware is provided through the Data Acquisition Toolbox Support Package for National Instruments NI-DAQmx Devices. This support allows you to perform the following tasks in MATLAB:

  • Read data from analog input channels (oscilloscope)
  • Write data to analog output channels (function generator)
  • Read and write data to the eight digital input and output channels
  • Setup and configure the NI myDAQ Counter/Timer
  • Configure the sampling rate of the NI myDAQ device

Related Hardware Support Views: MATLAB, Consumer Electronics, Data Acquisition Toolbox, MATLAB Product Family, MathWorks Supported, National Instruments, Project-Based Learning, Signal Processing Toolbox, Support Package Installer Enabled, Test and Measurement, USB

Ready to install?

Before installing the support package, confirm you have the correct setup. View system requirements and installation options.

Get Support Package

Software

Required

Recommended

Support Package

Required

Support Package Installer installs this support package. To start the installer, go to the MATLAB toolstrip and click Add-Ons > Get Hardware Support Packages. For more information, read the documentation.

Get Support Package

Hardware

Required

Don't see the hardware you're looking for?