Board-Specific Setup Information

Intel Arria 10 SoC development kit

To set up the board:

1. Plug in the power cord, and then connect the host computer to the FPGA board by using a JTAG cable.

   Note

   For setting up the boards, you do not need an Ethernet cable or an SD card.

2. Specify the SW3 switch settings.

   Bit 1	Bit 2	Bit 3	Bit 4	Bit 5	Bit 6	Bit 7	Bit 8
   Off	On	On	On	On	Off	Off	Off

3. Connect two DDR4 plugin boards to the memory plugin slot.

This figure shows the configuration settings for the Intel^® Arria^® 10 SoC development kit.

To learn more about the board configuration, see the Arria 10 SoC Development Kit User Guide.