Setup and Configuration

Install hardware support, update firmware, configure hardware connection

The embedded target for Intel^® SoC devices enables you to:

Build a Simulink^® model that loads and runs an executable on the ARM^® Cortex^®-A processor in the Intel SoC device.
Use the capabilities and features described in Supported Features for Intel SoC Platform.

To get this embedded target, perform the steps described in Add Support for Intel SoC Platform.

Functions

alterasoc Display most recent IP address, user name, and password

Build, deploy, and run models on connected hardware boards (Since R2019b)

Add Support for Intel SoC Platform
Install support for Intel SoC platform.
Supported Features for Intel SoC Platform
Supported features for Intel SoC platform.
Guidelines for Entering Static IP Settings
Guidelines for entering static IP settings.
Command Line Session with Intel SoC Device
Instructions on how to open a command line session to an Intel SoC device.
Hardware Setup Verification
Description of how the Embedded Coder^® Support Package for Intel SoC Devices verifies the setup of the Intel SoC hardware boards.

You can get the IP address of the Intel SoC hardware from the MATLAB^® Command Window or using the Linux^® command line.

Process to PING an Intel SoC hardware board connected to your development computer.

Configure a Network Interface Card (NIC) on development computer to connect to hardware board.

Use Embedded Coder® Support Package for Intel® SoC Devices to run a Simulink® model on an Intel SoC device.