This example shows how to flash the onboard LED when you press a button that is connected to a GPIO pin.
Excessive voltage and current can damage the BeagleBone Black hardware. Observe the
manufacturer precautions for handling the BeagleBone Black hardware and connecting it to
other devices. For more information, see the local copy of the BeagleBone drivers and
documentation in the
BeagleBone Black Getting Started folder on your host
computer, or https://beagleboard.org/Support/Hardware%20Support.
Using a breadboard, set up the following circuit:
Connect one of the +3.3V pins on the GPIO header to a button.
Connect pin 23 on the GPIO header to a 220 or 330 Ω resistor.
Connect the unconnected ends of the button and resistor to each other.
showLEDs function to show
an illustration that identifies each pin.
The figure shows the output of a call to
Run the code and press the button. The button closes the
circuit between the +3.3V pin and pin 23. When
the raised voltage,
writeLED toggles the LED on and off ten times.
for ii = 1:100 buttonPressed = readDigitalPin(bbb,'P9_12') if buttonPressed for jj = 1:10 writeLED(bbb,'usr0',1) pause(0.05) writeLED(bbb,'usr0',0) pause(0.05) end end pause(0.1) end
To restore LED
'usr0' to its default, which
is to indicate Linux® kernel activity, restart the BeagleBone