# Battery Sizing and Automotive Electrical System Analysis

### Overview

This example shows how to model a typical automotive electrical system as an architectural model and run primitive analysis. The elements in the model can be broadly grouped as either source or load. Various properties of the sources and loads are set as part of the stereotype. The example uses the iterate method of the specification API to iterate through each element of the model and run analysis using the stereotype properties.

### Structure of the Model

The generator charges the battery while the engine is running. The battery, along with the generator supports the electrical loads in the vehicle, like ECU, radio, and body control. The inductive loads like motors and other coils have the InRushCurrent stereotype property defined. Based on the properties set on each component, the following analyses are performed:

• Total KeyOffLoad

• Number of days required for KeyOffLoad to discharge 30 percent of the battery

• Total CrankingInRush current

• Total Cranking current

• Ability of the battery to start the vehicle at 0 degrees F based on the battery cold cranking amps (CCA). The discharge time is computed based on Puekert coefficient (k), which describes the relationship between the rate of discharge and the available capacity of the battery.

### Load the Model and Run the Analysis

```archModel = systemcomposer.openModel('scExampleAutomotiveElectricalSystemAnalysis'); % Instantiate battery sizing class used by the analysis function to store % analysis results. objcomputeBatterySizing = computeBatterySizing; % Run the analysis using the iterator. archModel.iterate('Topdown',@computeLoad,objcomputeBatterySizing); % Display analysis results. objcomputeBatterySizing.displayResults; ```
```Total KeyOffLoad: 158.708 mA Number of days required for KeyOffLoad to discharge 30% of battery: 55.789. Total CrankingInRush current: 136 A Total Cranking current: 177.5417 A CCA of the specifed battery is sufficient to start the car at 0 F. ```

### Close the Model

```bdclose('scExampleAutomotiveElectricalSystemAnalysis'); ```

Get trial now