how to detect point before it went on plateau
14 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Sharah
le 16 Juin 2014
Réponse apportée : Star Strider
le 16 Juin 2014
Hello everyone, I am new to matlab and I am doing a force analysis. I would like to detect a point in matlab before it went on a plateau, for example, this picture below (taken from a journal)
but from my graph, i can only able to detect the peak point, not the plateau, example below
(top picture) i am not sure how to find the minimum point of plateau (green line graph) and the point until it start to go down again, and then plot a line through it, as well as label each point (tp, tr, tf). will somebody help me on this?
attached is my data for 3 forces and time.
2 commentaires
Image Analyst
le 16 Juin 2014
What is the algorithm described in the paper? Can't you just use the same method they did?
Réponse acceptée
Star Strider
le 16 Juin 2014
It looks as though the ‘LC Green’ signal is what you want. You might have to filter it first to eliminate the noise, but then I would take its derivative and test for the derivative being close to zero. That should approximately define the start and end points of the plateau.
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Fourier Analysis and Filtering dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!