How to convert custom simulink blocks (with inports and outports created for accessing hardware interfaces) inside a subsystem into non-virtual blocks?
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I'm working on a project which has custom simulink blocks (with inports and outports created for accessing hardware interfaces) within subsystem. But embedded coder didn't generate code for it stating its a virtual block. So how to convert these virtual blocks (Inports and Outports) inside a subsystem into non-virtual blocks? Or is there any other way so that embedded coder will generate code for it.
0 commentaires
Réponses (1)
Fangjun Jiang
le 3 Avr 2024
Select the Subsystem block, right click, select "Block Parameters (Subsystem)", check "Treat as atomic unit".
This is one of the ways to change between virtual and non-virtual.
6 commentaires
Fangjun Jiang
le 10 Avr 2024
This block is an empty Subsystem block. There are no Port blocks inside. The port icon and label are from the "mask" of the Subsystem block. Select the block, right click, select Mask, Edit Mask, look at the Icon panel.
Thare are nothing there.
There are some codes related to the mask initialization but nothing indicates anything related to the embedded code generation.
Voir également
Catégories
En savoir plus sur Deployment, Integration, and Supported Hardware dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!