Different gripper mass but no changing in torques
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Denizhan AKINCI
le 14 Juin 2024
Réponse apportée : Karsh Tharyani
le 18 Juin 2024
Hello,
I am currently working with two versions of the UR5 robotic arm: the original version and a modified version where I have only reduced the mass of tool0. However, during simulations using the inverse dynamics block in Simulink, I've observed that the torques do not appear to change between the two versions. This is unexpected because reducing the mass should affect the torques.
Could this behavior be considered normal? If not, what could be the possible reasons for not observing any changes? Is it because the tool0 has no inertia maybe ? The trajectories are generated by CHOMP and then fed into Simulink using minjerk polynomial trajectories to obtain the joint variables (q, qd, qdd), which are subsequently used in the inverse dynamics block. The model is quite basic.
0 commentaires
Réponse acceptée
Karsh Tharyani
le 18 Juin 2024
Inverse Dynamics should be affected by changing mass of a body. It will be helpful to take a look at your whole system to get a sense of what is going on. But, to illustrate, see the changed torque outputs.
ur=loadrobot('universalur5e',dataformat='row');
q=rand(1,6);
qd=q;
qdd=q;
inverseDynamics(ur,q,qd,qdd)
ur.Bodies{end}.Mass
ur.Bodies{end}.Mass=2;
inverseDynamics(ur,q,qd,qdd)
Hope that helps!
Karsh
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Assembly dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!