C2000 CAN Video example calls out eCAN, but blockset shows CAN and we have an RX Issue

We are using two 379D launchpads. The TX section works fine.

The RX, when we connect the two boards, the bus stops as if the RX model is not configured correctly. We checked everything.

Is there a known good example of this we can use to get started ?

[Ali]

its working now, 2023 and 2025 are fine

Answer 1

[Nivedita]

Hi Ali,

You can refer to these following examples for your usecase:

1. Communication using CAN blocks: https://www.mathworks.com/help/ti-c2000/ug/ecan-example.html
2. Communication using MCAN blocks: https://www.mathworks.com/help/ti-c2000/ug/getting-started-mcan-example.html

Please make sure to follow the pre-requisites which are mentioned in the examples as well.

Thanks,

Nivedita.