Import file .stl - parameters

I would like to import an .stl file. I proceeded like this:

fv = stlread('EXAMPLE.stl');                        
patch(fv,'FaceColor',       [0.8 0.8 1.0], ...
         'EdgeColor',       'none',        ...
         'FaceLighting',    'gouraud',     ...
         'AmbientStrength', 0.15);
grid off  
hold on 
axis equal  

But I wanted to get a figure with the outline. What should I change?

Answer 1

[Pratheek Punchathody]

Look into the following code which imports the sample .stl file into MATLAB and adds the geometry to the PDE model.

In the “pdegplot()” function change the parameter “FaceAlpha” to "0" so that only edges are shown from the geometry present in the .stl file

model = createpde; 
importGeometry(model,'cube.stl'); 
pdegplot(model,'FaceLabel','on', 'FaceAlpha',0) 

Results of the about code with the sample cube geometry is as shown below.

With “FaceAlpha = 1”

Results of the about code with the sample cube geometry is as shown below.

With “FaceAlpha = 0”

Refer this "Link" for further information on importing the .stl file and changing the parameters.

[Alberto Acri]

Thanks, but I had already seen that link. Using the createpde command I can't get what I want because the stl object is characterized by a mesh.