start to write for a specified location using fprintf
16 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
sermet OGUTCU
le 12 Juil 2021
Commenté : sermet OGUTCU
le 13 Juil 2021
FileName1='data_file';
result_1=23.9;
FileName2='data_file2';
result_2=21.9;
startingFolder='C:\Program Files\MATLAB';
if ~exist(startingFolder, 'dir')
startingFolder = pwd;
end
defaultFileName=fullfile(startingFolder, '*.txt');
[baseFileName, folder]=uiputfile(defaultFileName, 'Select a file');
if baseFileName == 0
return
end
fullFileName = fullfile(folder, baseFileName); %fullfile=building file
fid = fopen(fullFileName, 'w');
How can I write a text file (starting with line 2) for the results as following:
result_1 result_2
data_file: 23.9 data_file2: 21.9
0 commentaires
Réponse acceptée
Scott MacKenzie
le 12 Juil 2021
Here's a solution. Make sure you use "r+" when opening the file, otherwise you'll overwrite the first line.
fid = fopen('testdata.txt', 'r+'); % open file for reading and writing
fgetl(fid); % skip over 1st line
fprintf(fid','data_file: %.1f data_file2: %.1f\n', result_1, result_2);
fclose(fid);
5 commentaires
Walter Roberson
le 12 Juil 2021
When you switch between reading (fgetl() in this case) and writing (fprintf() in this case), it is necessary to perform an fseek() operation to inform the operating system to flush buffers. It is acceptable to fseek() by 0 bytes relative to the current position: you do not have to move the current position, just call fseek() to prepare for the switch.
fid = fopen('testdata.txt', 'r+'); % open file for reading and writing
fgetl(fid); % skip over 1st line
fseek(fid, 0, 'cof'); %prepare to switch from read to write
fprintf(fid','data_file: %.1f data_file2: %.1f\n', result_1, result_2);
fclose(fid);
Plus de réponses (1)
Scott MacKenzie
le 12 Juil 2021
fid = fopen('testdata.txt', 'w'); % change, as needed
fprintf(fid, ' result_1 result_2\n');
fprintf(fid','data_file: %.1f data_file2: %.1f\n', result_1, result_2);
fclose(fid);
5 commentaires
Scott MacKenzie
le 12 Juil 2021
@Walter Roberson Thanks for pointing this out. Is this documented anywhere? I don't see any mention of this in the fseek documentation.
Walter Roberson
le 12 Juil 2021
POSIX requirement.
When a file is opened with update mode ( '+' as the second or third character in the mode argument), both input and output may be performed on the associated stream. However, the application shall ensure that output is not directly followed by input without an intervening call to fflush() or to a file positioning function ( fseek(), fsetpos(), or rewind()), and input is not directly followed by output without an intervening call to a file positioning function, unless the input operation encounters end-of-file.
Voir également
Catégories
En savoir plus sur Debugging and Analysis dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!