How to dynamically change the Mask dialog box in Simulink
8 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I have created a dynamic mask, which change if the block parameter "Command" is equal to Reset. The Command is set when I click apply, then it hides the Channel and Channel Electrical Parameters inputs, see below
I would like to improve my mask and make it more dynamic, without the need to click on Apply.
I put the piece of code that is in my Mask Editor belwo. Can anyone advise on how to get access directly to the selected Command?
disp('AD5665r')
mask = Simulink.Mask.get(gcb);
switch get_param(gcb,'Command') % I suppose this is where I need to change the code
case {'Write_To_Input_Register_n' ,'Write_To_Input_Register_n_And_Update_all' ,'Write_To_And_Update_DAC_Channel_n'}
[control,handle]=mask.getDialogControl("ChannelA_param_container");
control.Visible='on';
mask.getParameter("Channel").Visible = 'on';
port_label('input', 1, 'VoltageSetpoint')
case 'Reset'
[control,handle]=mask.getDialogControl("ChannelA_param_container");
control.Visible='off';
mask.getParameter("Channel").Visible = 'off';
port_label('input', 1, 'ResetTrigger')
end
port_label('output', 1, 'i2c status')
0 commentaires
Réponse acceptée
Mark McBroom
le 1 Août 2021
I am assuming the code you provided is from the "Initialization" tab? You could try putting the same code in the "callback" for the Command parameter on the Mask Editor -> Parameter and Dialog pane.
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Author Block Masks dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!