From Load-Flow to EMT: Using MATPOWER with Simscape Electrical
Overview
In this webinar we will show a workflow that runs a positive-sequence load-flow and then uses information in the load-flow to programmatically build and execute an electromagnetic transient (EMT) simulation.
Highlights
Using an example 118 bus system, we will cover the following topics,
- Perform load flow studies in MATPOWER.
- Build programmatically an EMT model in Simscape Electrical using network data and load flow results from MATPOWER.
- Perform a large number of grid-connected asset placement studies using vectorized asset modeling.
- Perform sequential impedance scanning at several network locations.
Please allow approximately 45 minutes to attend the presentation and Q&A session. We will be recording this webinar, so if you can't make it for the live broadcast, register and we will send you a link to watch it on-demand.
About the Presenter
Graham Dudgeon is Consultant Product Manager for Electrical Technology at MathWorks. Over the last two decades, Graham has supported several industries in the Electrical Technology area, including Aerospace, Marine, Automotive, Industrial Automation, Medical Devices, and Power & Utilities. Graham’s technical experience covers Transmission & Distribution, Grid Integration, Renewable Energy, Power Conversion, Motors & Drives, Microgrids, Electric Aircraft, Electric Ship, and Electric Vehicle, with an emphasis on system modeling and simulation, control design, and data analytics. Prior to joining MathWorks, Graham was Senior Research Fellow at the Rolls-Royce University Technology Centre in Electrical Power Systems at the University of Strathclyde in Scotland, UK.
