Diagnostics

Undertake spectral analysis of signals. You can either use recorded data from a file, or receive signals in real time using the RTL-SDR radio, ADALM-PLUTO radio, or USRP™ radio. You can change the radio's center frequency to tune the radio to a band where a signal is present. You can then use the spectrum analyzer to view and make measurements on the received spectrum.

Use Simulink® to undertake spectral analysis of signals. You can tune the radio to a band where a signal is present by changing the center frequency. You can then use the spectrum analyzer to view and make measurements on the received spectrum. You can either use recorded data from a file, or receive over-the-air signals in real time using an RTL-SDR radio, ADALM-PLUTO radio, or USRP™ radio.

Synchronize both the baseband sample rate and the center frequency of two PlutoSDRs by using the Frequency correction parameter of the ADALM-PLUTO Radio Receiver block.

Synchronize both the baseband sample rate and the center frequency of two PlutoSDRs by using the FrequencyCorrection property of comm.SDRRxPluto and comm.SDRTxPluto.

These two models show how to determine the relative frequency offset between two ADALM-PLUTO radios.