The conversion of a model from floating point to fixed point requires configuring fixed-point instrumentation and data type overrides. However, leaving these settings on after the conversion can lead to unexpected results.
The Fixed-Point Tool automatically enables fixed-point instrumentation and overrides the data types in your model with doubles when you click the Collect Ranges button in the tool. When the simulation or derivation is complete, the tool automatically disables the instrumentation and removes the data type override. When you click the Simulate with Embedded Types button, the tool enables instrumentation during the simulation. Data type override settings on the model are not affected.
The fixed-point instrumentation mode controls which objects log minimum, maximum, and overflow data during simulation. Instrumentation is required to collect simulation ranges using the Fixed-Point Tool. These ranges are used to propose data types for the model. When you are not actively converting your model to fixed point, disable the fixed-point instrumentation to restore the maximum simulation speed to your model.
To enable instrumentation outside of the Fixed-Point Tool, at the command line set the
MinMaxOverflowLogging parameter to
Instrumentation requires a Fixed-Point
Designer™ license. To disable instrumentation on a model, set the parameter to
Use data type override to simulate your model using double, single, or scaled double data types. If you do not have Fixed-Point Designer software, you can still configure data type override settings to simulate a model that specifies fixed-point data types. Using this setting, the software temporarily overrides data types with floating-point data types during simulation.
To observe the true behavior of your model, set the data type override parameter to