Variant configuration not used by top model
Diagnostic action to take when variant configuration of a top model does not use an existing variant configuration of a referenced model
Since R2022b
Model Configuration Pane: Diagnostics
Description
The Variant configuration not used by top model parameter applies to
models that have variant configurations defined using Variant Manager for Simulink®. The parameter specifies the diagnostic action to take when a top-level
model references this model but does not use one of the predefined configurations of
this model to set up its own variant configurations. Use this parameter to help verify
that this model is used only for its tested variant configurations when referenced by
another model. When you set this parameter to warning or
error, the software issues the diagnostic when you
compile the top model or activate the top model configurations using Variant
Manager.
Settings
warning (default) | error | nonenoneThe software does not issue a diagnostic if the top model does not use this model in one of its published variant configurations.
warningThe software issues a warning if the top model does not use this model for one of its published variant configurations. To suppress the warning and continue with simulation, click Suppress.
errorThe software issues an error and terminates the simulation if the top model does not use this model for one of its published variant configurations.
Recommended Settings
| Application | Setting |
|---|---|
| Debugging | No impact |
| Traceability | No impact |
| Efficiency | No impact |
| Safety precaution | No impact |
Programmatic Use
Parameter: VariantConfigNotUsedByTopModel |
| Type: string | character vector |
Values:
"none" | "warning" |
"error" |
Default:
"warning" |
Version History
Introduced in R2022b
