bwlabel changing connectivity of image
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am trying to use BWLabel to label 1 pixel width line segments. These lines are not straight so I am using a connectivity of 8. When I run bwlabel and view the image of the newly labeled skeleton, it actually is changing layout, size and connectivity of the line segments. The input image is a double. I am using Matlab R2009b.
Am I asking bwlabel to be too sensitive? I am using this as part of a larger code that is trying to find the angle of these segments by using the segment endpoints, so maintaining separation is important.
Below is the code I used to generate the two supplied images
% A = image to be labeled.
figure(1), imshow(A)
A2 = bwlabel(A,8);
figure(2), imshow(A2)
0 commentaires
Réponse acceptée
Image Analyst
le 31 Mai 2012
Your A image is not what you think it is. I'd bet that it is not a logical image, but a gray scale image with most pixels at 255 but some pixels at a much darker value. Do this
imhist(A);
and see what it shows. Do you have only 2 bins at 0 and 1? Or do you have bins at 0, 255, and, say, 20 or some small number?
You can also try this
A = (A == 255); % Convert to logical image with 1 only where A = 255.
and then label and see what you get.
5 commentaires
Plus de réponses (1)
Stephen
le 31 Mai 2012
I agree with Image Analyst. Is your image a jpg or has it been compressed? If so, there are little ghosts that lurk as low intensity values on certain pixels. bwlabel uses any value above 0 (or below?) so those sneaky pixels will get marked. Take a look at what a==0 looks like, or type unique(a) to see a list of the unique intensity values.
0 commentaires
Voir également
Catégories
En savoir plus sur Image Processing Toolbox dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!