IO Device Builder
L’application IO Device Builder de Simulink® Support Package for Arduino® Hardware vous permet de créer rapidement un System object™ pour des fichiers sources personnalisés ou tiers (C/C++). Vous pouvez vous servir de System object pour créer un bloc Simulink utilisant le bloc MATLAB® System.
Pour utiliser l’application IO Device Builder, accédez à l’onglet Hardware dans Simulink Toolstrip et allez dans Prepare > Design > IO Device Builder. Une série d’instructions vous guide dans la création d’un System object et d’un bloc Simulink.
Rubriques
- Get Started with IO Device Builder
Understand system requirements and work with IO Device Builder.
- Working with Arduino Libraries in IO Device Builder
Instructions to handle Arduino Libraries in IO Device Builder.
Informations connexes
Sélection d՚exemples
Create DHT11 Sensor Block to Measure Relative Humidity and Temperature Using IO Device Builder App
Use the IO Device Builder app to create DHT11 sensor for measuring relative humidity and temperature. In this example, the DHT11 sensor communicates with a microcontroller through a single-wire interface. The communication protocol is a proprietary one-wire protocol that uses a timing-based communication scheme. It detects water vapor by measuring the electrical resistance between two electrodes, and it measures temperature with a surface-mounted NTC temperature sensor (thermistor) built into the unit.
Create ADXL343 Sensor Block to Read Acceleration Using IO Device Builder App
Use the IO Device Builder app to create ADXL343 sensor to measure acceleration. In this example, the ADXL343 sensor values are retrieved by using the SPI bus requiring four wires (SCL, SDA, SDO and CS).
Create OLED Display Block to Display Acceleration Using IO Device Builder App
Use the IO Device Builder app to create ADXL343 sensor to measure acceleration and display the same in SH1106 OLED (Organic Light Emitting Diodes) display module.
Create OLED Display Block to Display Acceleration and Tap Count Using IO Device Builder App
Use the IO Device Builder app to create OLED Display block to measure acceleration, tap count and then display the same in OLED (Organic Light Emitting Diodes) display module.
Create OLED Display Block to Display Acceleration and Tap Count Using Arduino External Interrupt Block and IO Device Builder App
Use the IO Device Builder app to create OLED Display block to display acceleration and tap count using Arduino External Interrupt block.
