PWM Write

Send pulse width modulation (PWM) signal configuration to PWM Interface block

Since R2020b

• 

Libraries:
SoC Blockset / Processor I/O

Description

The PWM Write block sets the duty cycle for a PWM peripheral. In simulation, the block passes through the duty cycle input to drive the PWM Interface block that simulates the PWM switching signals produced by the hardware. When deployed to hardware, the PWM Write block writes to the appropriate PWM drivers on the hardware.

Examples

Integrate MCU Scheduling and Peripherals in Motor Control Application

Identify and resolve issues with respect to peripheral settings and task scheduling early during development.

• Open Model

Ports

Input

Compare — Comparator trigger value

positive scalar | N-length positive vector

Specify the comparator values that trigger the change in pulse-width modulation waveform. When a N is 1, the comparator value defines the duty cycle of the PWM waveform. Using 2 comparators and the settings provided in the PWM Interface block, more fine grained control of the output waveform can be achieved.

Data Types: single | double

Period — Period of PWM waveform

positive scalar

Specify the total period of the PWM waveform.

Dependencies

This parameter is only available when the Show period as input parameter is enabled.

Data Types: single | double

Phase — Phase offset of the waveform

scalar from 0 to PWM period

Specify the phase of the PWM waveform relative period of waveform. The phase is represented as a scalar between 0 and PWM period.

Dependencies

This parameter is only available when the Show phase as input parameter is enabled.

Data Types: single | double

Output

msg — PWM duty cycle values

scalar

This message port sends duty cycle values as messages to a connected PWM Interface block. For more information on messages, see Messages.

Note

This output is used only during simulation and is ignored in code generation and external mode simulation.

Data Types: SoCData

Parameters

Show period as input — Show period input port

off (default) | on

Show a Period input port on the block. This port accepts a dynamic period value for the PWM waveform, allowing the period of waveform to be modified during execution.

Show phase as input — Show phase input port

off (default) | on

Show a Phase input port on the block. This port accepts a dynamic phase value for the PWM waveform, allowing the phase offset of the waveform to be modified during execution.

Extended Capabilities

C/C++ Code Generation

Generate C and C++ code using Simulink® Coder™.

When deployed to a supported hardware board, this generated code for this block writes to the PWM registers in the MCU for the specified PWM module. For more information on configuring the register settings, see Hardware Mapping.

Note

Supported hardware boards include the TI Delfino F2837xD and TI Delfino F2837xD LaunchPad from the SoC Blockset™ Support Package for Texas Instruments^® C2000™ Processors.

Version History

Introduced in R2020b