How to observe the output of the Modelsim blockset using scope?

1 vue (au cours des 30 derniers jours)

Milruwan le 30 Déc 2013

0
Lien

Utiliser le lien direct vers cette question

https://fr.mathworks.com/matlabcentral/answers/111046-how-to-observe-the-output-of-the-modelsim-blockset-using-scope

Modifié(e) : Milruwan le 31 Déc 2013

I simulate a matlab co simulation project using modelsim. I created a fixed point filter using fdatool and co simulate it. I successfully observed the output from the modelsim but the matlab scope gives a blank output. what is the reason? How can I observe the output using scope?