Arduino Simulink Analog input
29 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I AM USING A AUDRINO ANALOG INPUT PIN TO DISPLAY A VOLTAGE. WHEN I RUN THE MODEL ON TARGETED HARDWARE I ENDED UP GETTING ZERO. CAN ANY ONE HELP ME...
0 commentaires
Réponses (3)
Rolfe Dlugy-Hegwer
le 7 Fév 2014
Hi Anil, It sounds like you clicked the Run (green triangle) button, which simulates the model on your host computer. Try clicking the Deploy to Hardware button instead. See http://www.mathworks.com/help/simulink/ug/run-model-on-arduino-hardware.html
4 commentaires
Terry Ramsey
le 16 Fév 2014
Modifié(e) : Terry Ramsey
le 16 Fév 2014
my blocks being used are: Analog Input (pin 0). I have pin 0 on arduino connected to an analog input(a potentiometer with 0-5V in this case). Sample time = 0.5. A Display block. Short format. Decimation = 1. They are connected together.
Not sure why this isnt working.
zeghib okba
le 10 Mai 2016
Modifié(e) : zeghib okba
le 10 Mai 2016
Hi Anil, the problem may be doing from 2 things:
1- you should be using arduino mega2560 for display a voltage.
2- You may be inverted the signal, because arduino is not accepted negative signal.
0 commentaires
Tal Dachlika
le 29 Jan 2018
I had the same problem with arduino uno and I fixed it, just change the mode to external: simulation->mode-> external.
1 commentaire
Quang Huy
le 10 Jan 2021
I had the same problem with arduino uno. I tried it the way you do but not sucessfull.
Voir également
Catégories
En savoir plus sur Arduino Hardware dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!