In simulink plot time range gets locked

When I plot a figure in real time. time range is set as 100 seconds. The plot get stopped after 50 seconds.

In simulink real time following parameters are set: Solver options Fixed step size:0.0005 Solver:ode4 Runge Kutta In scope: sampling time is :0.0005

Any help please

Answer 1

[Anuj]

Have You unchecked limit data points to last?

[abhijit kulkarni]

Yes I unchecked that. Still the problem is same.

[Anuj]

Do you get any error/warning? Does simulation stop after 50s or only the plot you get is for 50s?

[abhijit kulkarni]

No error message and simulation works for complete 100 seconds well.

[Anuj]

It seems You have specified 100 s time range in scope and your simulation time is different. If so, change the scope block time range to auto and run simulation for the time period for which you need plot. It should work, Otherwise you can consider uploading your model.

Regards

[abhijit kulkarni]

Did Auto. Doesnt make any improvement.

I observed in : Simulation\Configuration parameters\Data Import Export\Limit Data Point To Last is set to 1000 with Decimation of 1. Format is array.

Does that make any problem?

[Anuj]

If you are plotting the signal using command window, there might be some problem, are you plotting it through command or through scope block? and what is the simulation time you are using?

[abhijit kulkarni]

Thr scope. Simulation time is 100 seconds.

[abhijit kulkarni]

Unfortunately thats not possible.