Optimtool for nonlinear constrained optimization - Bounds on design variables
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello,
i am using Optimtool for nonlinear constrained optimization.
After writing down two separated files for the objective function and the set of nonlinear constraints, it must be indicated also the lower and upper limits for each of the n-design variables x(1),x(2),...,x(n).
Suppose that x(1) [0.001, 0.05]; and x(2) = [0.7,2];
How one should indicate this? is is correct to write: lb =[0.001, 0.05] and ub = [0.7 2] ?
thanks
0 commentaires
Réponse acceptée
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Problem-Based Optimization Setup dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!