How do end a task on Zynq when using "Build, Deploy and& Start"?

1 vue (au cours des 30 derniers jours)

丹姚 le 26 Sep 2021

0
Lien

Utiliser le lien direct vers cette question

https://fr.mathworks.com/matlabcentral/answers/1460924-how-do-end-a-task-on-zynq-when-using-build-deploy-and-start

Hello all,

I uses Matlab 2020b and Xilinx Zynq UltraScale+ MPSoC ZCU102 evaluation kit for model based development.

I found that when I building ARM executable, "Monitor &Tune" will start a task that follows my "Stop Time", but when I use "Build, Deploy and& Start", the task will not stop until I powered off my Zynq board.

So how to build a task with stop time on Zynq when using "Build, Deploy and& Start"?

Thanks a lot

0 commentaires
Afficher -2 commentaires plus anciensMasquer -2 commentaires plus anciens

Connectez-vous pour commenter.

Connectez-vous pour répondre à cette question.

Réponses (0)

Connectez-vous pour répondre à cette question.

Catégories

Code Generation HDL Coder HDL Coder Supported Hardware Xilinx FPGA and SoC Devices

FPGA, ASIC, and SoC Development HDL Coder HDL Coder Supported Hardware Xilinx FPGA and SoC Devices

En savoir plus sur Xilinx FPGA and SoC Devices dans Help Center et File Exchange

Produits

Version

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by