can we control Data Inspector from command line ?

I am using Data logger in 2013 with one of my model.

After configuring the signals to log , I run a script which simulates my model several times ( I give simulation start and stop commands in the script)

Once do that, I can see too many runs in the data inspector.

I can delete the these runs using command line simulink.sdi.deleterun but is it possible to prevent the run from being captured by Data Inspector ? rather than deleting it later ?

Answer 1

[Astik Sachan]

Hi, You may want to look at following links:-

Simulink Data Inspector Command: Simulink.sdi.view

Inspect and Compare Data Programmatically Command: Simulink.sdi.getRun

Answer 2

[Frank Zhou]

There is a related question with an answer on this thread:

https://www.mathworks.com/matlabcentral/answers/462334-simulation-data-inspector-unnecessarily-archives-data-and-overloads-filesystem

Hope this helps!