Can't Get ThetaZeroLocation to Work Properly Using polarplot
14 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Peter Beringer
le 4 Déc 2021
Modifié(e) : Peter Beringer
le 5 Déc 2021
Hi all,
I have binaural audio measurements made with a head and torso simulator on a turntable. Impulse response were measured for 81 angles at 3° increments (so, 240° to 120° via 0°) to cover the maximum rotation of a human head (and beyond). So, the angle values are a vector ...
Angles = [240:3:357, 0:3:120]; % Vector of angle/azimuth positions
But when I try to plot with the zero location at 'top' (i.e., "north", "12 o'clock", etc.), it stays at the default of 'right. No other directions work either. My feeling is that the ordering of my angles vector is interfering, but I have no idea why - it plots how I'd like, just on its side.
The example here works fine:
... but not with my angle vector as the theta value, which is what leads me to think that's the issue. The full plotting code I'm using (with random numbers for simulated data) is ...
Angles = [240:3:357, 0:3:120]; % Vector of angle/azimuth positions
theta = deg2rad(Angles);
rho = rand(1,81);
ax = polaraxes;
ax.ThetaZeroLocation = 'top';
polarplot(theta,rho);
Many thanks in advance for any advice or suggestions people have. Cheers!
0 commentaires
Réponse acceptée
Adam Danz
le 4 Déc 2021
Modifié(e) : Adam Danz
le 4 Déc 2021
You have to either hold the axes after setting ThetaZeroLocation or set ThetaZeroLocation after plotting. Otherwise, when you plot using polarplot it resets the properties.
Angles = [240:3:357, 0:3:120];
Angles = [240:3:357, 0:3:120]; % Vector of angle/azimuth positions
theta = deg2rad(Angles);
rho = rand(1,81);
ax = polaraxes;
ax.ThetaZeroLocation = 'top';
hold(ax, 'on') % <----------- hold
polarplot(theta,rho);
4 commentaires
Steven Lord
le 5 Déc 2021
This behavior is not limited to polarplot. High-level plotting functions basically call newplot before they create their lines, surfaces, etc. newplot checks certain figure and axes properties to determine how to prepare the figure and axes for those new lines, surfaces, etc. hold changes those figure and axes properties. See the documentation page for more details.
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Polar Plots dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!