Simulink coder and disabled subsystems
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I'm trying to generate code from a Simulink diagram which contains an enabled subsystem. The enable is tied to a workspace variable that is always 0 (the subsystem should never be enabled). Still, it seems that the coder tries to generate code from this system. Why is this happening? Can I stop it from happening?
Thanks
0 commentaires
Réponses (2)
Paolo
le 7 Avr 2015
I have the same problem. It seems that the optimization "Simulation and code generation -> Block reduction" doesn't properly work in this case.
0 commentaires
TAB
le 7 Avr 2015
Check if
Optimization > Inline Parameters
option is selected.
If this option is not selected, then Simulink will assume every parameter as tunable and it will be included in code independent of its value.
0 commentaires
Voir également
Catégories
En savoir plus sur Simulink Coder dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!