- Work from Code Compiler Studio to make a connection to the target.
- Then use the '.ccxml' from the Code Compiler Studio in MATLAB and try to establish the connection.
- After downloading the code successfully, connect the serial port from debugger to 'SCI_A Rx' and 'Tx' pins on board from external mode.
XDS100 Embedded coder support error
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am using F28379D to simulate LED blinking example using embedded coder support error.
I think I chose right hardware board and set target hardware resourses correctly.
But I get the error message as below.
I checked the device manager and saw that the new version of XDS100v3 is detected correctly as below
Anyone know what the problem is?
Thank you in advance.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1071380/image.png)
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1071385/image.png)
0 commentaires
Réponses (1)
Vignesh
le 9 Oct 2023
Hello 종석 김,
I see that you are encountering errors while running LED blink example and you are working on F28379D.
I suggest you try the below steps as a workaround and check if is working at your end:
I hope this answer helps you overcome the error you are facing.
0 commentaires
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!