New to GUI. I have imported and read an xlsx file into a table. The data is latitude longitude roll pitch yaw and I have an equation that calculates EL AZ given t

New to ML and GUI. I have imported and read an xlsx file into a table. The data is latitude longitude roll pitch yaw and I have an equation that calculates EL AZ given two different longitudes and one latitude (respective to one of the longitudes). I don't know how to use the lat lon data from the table (form the imported xlsx file) and incorporate it into that equation over a time step outputing the results.

I'm sure this is not a well stated question and I apologize but I will happily accept any assistance.

This is what I have ::

CODE TO CREATE TABLE:

fileName='LLRPYT.xlsx';
            xlsread(fileName);
t=readtable("LLRPYT.xlsx");
vars=["Lat","Lon","Roll","Pitch","Yaw","Time"];
t=t(1:61,vars);
fig=uifigure;
uit=uitable(fig,"Data",t,"Position",[100 100 850 800]);



%%CODE to hopefully take the data from that table and run it through this
%%equation over a time step and output AZ EL

%This is the equation, where lons is longitude of a hypothetical satellite
%and lonv is that of a vehicle, lats is latitude of satellite 

atand((tand(lons-lonv))/(sind(lats)))

Answer 1

[Walter Roberson]

atand((tand(t.Lon-lonv))./(sind(t.Lat)))

possibly?