There is a bug in the realtime udp receiver block. Below a certain amount of bytes, the block will not receive any byte. Actually I am testing a patch of MathWorks. In a short time the patch will be available on MathWork's support page.
xpc realtime udp receive
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Does anybody have a short example how to use an xpc realtime udp receiver block? I am able to write out an udp packet to a "sensor" which will answer after receiving the packet. To check the answer, I am using wireshark. But I am not able to receive this packet with the xpc target.
It seems to me, that the xpc realtime receiver block is misconfigured or has a bug, may be the packet size is too short?
Was anybody able to use this receiver block successfully?
0 commentaires
Réponses (4)
Mirko Kunze
le 22 Mar 2012
Any updates on this issue? I have the same problems and did not find any patches.
0 commentaires
Peter Wehrli
le 22 Mar 2012
2 commentaires
Celine Chia
le 11 Juin 2012
Erm,
how do you do you find the bug report 783622? do you have the link?
I googled it and nothing.
Walter Roberson
le 11 Juin 2012
Bug reports can generally be found at http://www.mathworks.com/support/bugreports/
That particular one is either not present or not publicly visible.
Rajiv Ghosh-Roy
le 11 Juin 2012
I think you need to set the "release exists in" to R2011b.
0 commentaires
Voir également
Catégories
En savoir plus sur Target Computer Setup dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!