problem with transmission block simscape
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello, I'm modelling a vehicle transmission with the block "transmission" that you can find in simscape. It's an 8 speed transmission, I set the logic to change gear, but the vehicle stops at 2 km/h. If I use a simple gear with a certain gear ratio it works. If i keep the transmission connected and i increase by 100 times the inertia of the engine it slowly accelerate. what I should check, is there a recent example where the transmission block is used? thank you
0 commentaires
Réponses (1)
Akshat
le 2 Oct 2023
Modifié(e) : Akshat
le 3 Oct 2023
I understand that you are facing issues while leveraging the 'transmission' block in Simscape. Since your focus is on 8-speed transmission, the following references could provide valuable insights and assist you in resolving the issue.
I hope this helps.
0 commentaires
Voir également
Catégories
En savoir plus sur Automotive Applications dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!