- If the Dashboard Scope block is inside a referenced model, the plot does not update during simulation.
- No support for rapid accelerator simulations.
- Signals that are reduced through optimizations such as block reduction or accelerator mode aren't displayed in the plot. To view such a signal, mark the signal for logging.
How to eliminate delays in drawing a graph during modeling in Simulink, in a dashboard?
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I work in Simulink.
I am making a model with cyclic calculations. The model is complex, I’m struggling with speed, trying to optimize the calculations.
To visualize the results of the cycles during the calculations, I would like to use a graph. I took it from the dashboard...
But the results are not displayed on the graph in simulated time. There are long delays in displaying monitored parameters on the graph.
Sometimes the display is formed only after all modeling cycles have been completed.
Is it possible to eliminate the delay in drawing graphs in Simulink, in a dashboard?
0 commentaires
Réponses (2)
Sara Nadeau
le 7 Oct 2023
Have you looked into any of the limitations listed in the documentation for the Dashboard Scope block?
Notable limitations include:
Does the plot update after the simulation ends?
9 commentaires
Sara Nadeau
le 9 Oct 2023
Ah, I see. I'm not sure beyond those limitations what might explain these behaviors that you describe.
Unfortunately, I'm also not aware of any setting that would allow you to force updates every calculattion cycle.
Image Analyst
le 1 Oct 2023
I don't know Simulink, but it MATLAB you'd call
drawnow;
to force an immediate update/refresh of the screen and plots.
2 commentaires
Voir également
Catégories
En savoir plus sur Dashboard dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!