Simulink block from workspace
3 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am new to matlab. I have some problems when I use the simulink block 'from workspace'.First, I opened a file in the command window.the first column of the file is time information and the second column is the signal value. Let say the name displayed on the workspace for the file is V1. Then,I placed the block 'from workspace' in simulink. I put V1 for the block parameter, 'Data:'. It pop up an error message 'invalid matrix format'. May I know what should I change to be able to get the information from the workspace?
0 commentaires
Réponses (2)
Fangjun Jiang
le 8 Nov 2011
What file are you open, .mat or .txt or something else?
In Command Window, do the following,
t=(0:0.1:10)';
y=sin(t);
simin=[t y]
Then drag a "From Workspace" block to an empty model, drag a scope, connect it and run the simulation. Do you see a sine curve in the scope?
3 commentaires
Fangjun Jiang
le 9 Nov 2011
What do you get if you run size(t) and size(y)? Is the data in t strictly incremental?
Guy Rouleau
le 9 Nov 2011
Modifié(e) : John Kelly
le 27 Fév 2015
I recommend going through the "Importing Signal Data in Simulink" section of the doc:
Depending on your task, the table "Guidelines for Specifying Time and Signal Values for Imported Data" will help you implementing the most appropriate method.
1 commentaire
charanarur panem
le 9 Juil 2018
please help for the workspace simulink problem.Actaully i gave input 100x50 data,but workspaceoutput shows 1100x50,please tell me how to get 100x50 data matrix
Voir également
Catégories
En savoir plus sur Naming Conventions dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!