beamwidth vs bandwidth
44 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Negar
le 26 Fév 2011
Réponse apportée : Shriya Namani
le 21 Juin 2021
Hello all , Can someone tell me what the difference between beamwidth and bandwidth is?
0 commentaires
Réponse acceptée
Plus de réponses (2)
chris hinkle
le 27 Fév 2011
Bandwidth refers to the amount of the frequency spectrum that a signal resides in, example the spacing between channels on your radio are determined by their bandwidth.
Beamwidth is a physical characteristic of an antenna. They generally mark the point from bore sight of a directional antenna that you are at.-3dB or half power
0 commentaires
Shriya Namani
le 21 Juin 2021
The angular separation between the points at which the magnitude of the radiation pattern decreases by 50% (or -3dB) from the peak of the main beam is called as the Half-Power Beamwidth (HPBW).The angular span between the first nulls adjacent to the main lobe in the radiation pattern is called as the First Null Beam Width(FNBW).
Bandwidth is the range of frequencies over which the antenna characteristics are within the acceptable value around the center frequency. For broadband antennas, the bandwidth is usually expressed as the ratio of the upper to lower frequencies of acceptable operation. For example, a 10:1 bandwidth indicates that the upper frequency is 10 times greater than the lower.
For narrowband antennas, the bandwidth is expressed as a percentage of the frequency difference (upper minus lower) over the center frequency of the bandwidth. For example, the upper and lower frequencies are 1010 MHz and 960 MHz respectively and the center frequency is 1000 MHz. The percentage bandwidth is ((1010 MHz- 960 MHz)/1000 MHz)*100 = 5%. This indicates that the frequency range of acceptable operation is 5% of the bandwidth center frequency.
0 commentaires
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!