Error while running monitor and tune on zedboard using matlab_2023 and xilinx2019.2

The hdl coder runs fine and I am able to upload the example code from led blinking example : hdlcoder_led_blinking. The code uploads to the zedboard and I can see the led's glowing. The problem happens when I try to run the interface file. I don;t see the monitor and tune option in the toolstrip, but i see the "configure, monitor and tune" option and when I click on it, I see the error : Error:FPGA or processor model not detected. You must launch SoC Builder from the top model. If the error persists, see Build Error for FPGA or Processor Model not Detected.

I am attaching a screenshot for reference. Any help will be appreciated.

Answer 1

[Abhishek Kumar Singh]

Hi Anuj,

To get the "Configure, Monitor & Tune" option working, you need to build your model with socBuilder as the error suggests. Just open the Command Window and type:

socBuilder('modelname')

For details on SoC Builder, check the documentation here: https://www.mathworks.com/help/ti-c2000/ug/socbuilder.html

Also, the "Configure, Monitor & Tune" option is under the MONITOR & TUNE section in the Hardware tab.

If you're still stuck after this, the solution might be in the troubleshooting steps here:

https://www.mathworks.com/help/soc/ug/build-error-for-fpga-or-processor-model-not-detected.html