Using PMSM model for electric vehicle simulation

3 vues (au cours des 30 derniers jours)
Alexandre Bitencourt
Alexandre Bitencourt le 14 Sep 2015
Modifié(e) : Alexandre Bitencourt le 11 Nov 2017
I'm using a PMSM model (the one in the AC6 example) for an electric vehicle and i want to simulate the motor ME1115. But there is no place in the model to change the power. So how exactly can i change that?

Connectez-vous pour répondre à cette question.

Réponses (1)

ahmad yasser
ahmad yasser le 11 Nov 2017
Did you find how to set the power rating of the motor?
  1 commentaire
Alexandre Bitencourt
Alexandre Bitencourt le 11 Nov 2017
Modifié(e) : Alexandre Bitencourt le 11 Nov 2017
You control the electrical power by inductances Ld and Lq, sadly my motor's datasheet didn't have this information, so i had to keep changing those values until find a good result. Keep in mind that Lq should be a little bit greater then Ld (look at the motor equation) and the controller must have the same Ld and Lq values, if he uses it.

Connectez-vous pour commenter.

Communautés

Plus de réponses dans  Power Electronics Control

Catégories

En savoir plus sur Green Vehicles dans Help Center et File Exchange

Tags

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by