How can i change the output power of a wind turbine induction generator in simpowersystems, and how can I measure the output power?
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello I've been trying to change the output power of a wind turbine induction generator from its menu window (shown below), but I can't figure out the change in power in the scopes I can't understand the resulting signals after I changed the nominal power.
Appreciate your help
0 commentaires
Réponses (2)
Joel Van Sickel
le 17 Sep 2020
Hello Qais,
you will also need to increase the power delivered to the motor. This will show up in the simulation as increase voltage and current.
Regards,
Joel
0 commentaires
Ibrahim Athamnah
le 3 Jan 2022
Hello Qais,
I have almost the same problem.
If you solve it, please send to me the solution. My email is:
2019979009@ses.yu.edu.jo
0 commentaires
Voir également
Catégories
En savoir plus sur Wind Power dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!