- 'Frequency' and 'sample time' of each of the three "sine wave" blocks you are using.
- The length of FFT .
How to analyse spectrum for frequency and magnitude in simulink
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi,
my goal is to analyse an ofdm-signal at the receiver site. I think therefor i have to sweep the FFT output for frequency and magnitude detection. With the magnitude i will conclude on the transmitted data for each subcarrier / frequency.
Now i worked out an easy ofdm-transmitter with three added frequencies, which should be modulated with a bitstream later.
But that output signal wasn't that i expected.
The same in detail:
So what did i wrong with the fft-signal or how can i use the complex signal for my application?
How is the complex signal made of and how can i sweep all frequencies for their magnitude?
Best regards!
1 commentaire
Jyotish Robin
le 1 Août 2016
It is not clear from your model what are some of the inputs of the "add" block you used. Kindly specify them. It will be useful if you could provide the following additional details:
Réponses (0)
Voir également
Catégories
En savoir plus sur OFDM dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!