Error when running deployed stand-alone application that uses mex files for c++ code
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi All,
I have created a standalone application using deploytool, which runs perfectly on the development computer. However, on other computers I get the error message "Error using mex. No supported compiler or sdk was found". The error is generated by the following line: "eval(['mex -g ', mexDistanceFile])", where mexDistanceFile is a c++ file. I am using Matlab R2014b. Any help would be much appreciated. Thanks!!
0 commentaires
Réponse acceptée
Kirby Fears
le 22 Juin 2016
Modifié(e) : Kirby Fears
le 22 Juin 2016
That error is thrown because the mex command attempts to compile a c++ file into .mex. You probably don't have the compiler on other machines. The code you distribute to other computers should be calling the pre-compiled library, not attempting to compile it again.
Check out this link describing how to compile a .mex file and then use it afterward.
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Write C Functions Callable from MATLAB (MEX Files) dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!