- First enable 'Signal Logging' in the Simulink Configuration Parameters
- Then label the signal you wish to log by double clicking and typing a name
- Click on 'Log/Unlog selected signals' tab in 'Record and Inspect Simulation Output'
Record & Inspect simulation output
4 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I'm doing a mass spring damper analysis. Then I wanted to record xd and x values to see how they change in simulator data inspector, but I did not see the"log/unlog selected signals" tab in Record and inspect simulation output
0 commentaires
Réponses (1)
Vishwas Bharadwaj
le 1 Nov 2016
Based on the description, I assume that the 'Log/Unlog selected signals' tab is grayed out and hence you are unable to see it.
To use the Simulation Data Inspector, you need to:
Another way to log the signal is to right click on the signal and select 'Properties'. In the Signal Properties dialog that appears, select 'Log signal data'. Press OK and close the Signal Properties dialog.
For further information about Simulation Data Inspector, you can refer to the documentation by executing the following commands in MATLAB Command Window:
web(fullfile(docroot, 'simulink/ug/simulation-data-inspector-overview.html'))
web(fullfile(docroot, 'simulink/ug/customize-the-simulation-data-inspector-interface.html#bsof7or'))
Hope this helps!
0 commentaires
Voir également
Catégories
En savoir plus sur Analyze Simulation Results dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!