How to switch between one plot and two subplots on a GUI?
7 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi all,
I created a GUI, using GUIDE, and in it I placed an axes. I have no problem to reach this axes and plot whatever on it. In some cases I want to use two subplots where this axes is located. I tried it and the original axes was deleted while two others, one for each subplot, were created. Now I can't return to the one axes configuration because it is gone.
What is the best approach to be able to switch between one plot and two subplots at the same place where the original axes is located?
Thanks,
Alon
0 commentaires
Réponses (2)
Jan
le 18 Déc 2016
SubPlotH = [subplot(2,1,1), subplot(2,1,2)];
AxesH = axes;
for k = 1:10
if rem(k, 2) == 1
set(SubPlotH, 'Visible', 'off');
set(AxesH, 'Visible', 'on');
else
set(SubPlotH, 'Visible', 'on');
set(AxesH, 'Visible', 'off');
end
pause(1);
end
3 commentaires
Jan
le 19 Déc 2016
No, the axes object is not deleted, "when you plot on the subplots". This deleting must have a cause. So please use the debugger at first to find the reason of the deleting, or at least the line, where it is deleted. Then post the relevant code.
Walter Roberson
le 23 Jan 2017
subplot always deletes any axes that it overlaps. You need to axes() up new axes. Or, design three axes in GUIDE and hide what is not in use, never calling subplot.
Voir également
Catégories
En savoir plus sur Subplots dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!