How can I add acceleration resistance to a driveline model?
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I have built a model using Simscape Driveline/Simulink. I have added gradient, rolling and wind resistance to the model; however, I am not sure how to add acceleration resistance to the model. Any suggestions?
0 commentaires
Réponses (1)
Steve Miller
le 7 Déc 2022
There are many ways to limit the acceleration. The resistances you have already added do that already. I believe you wish to limit the input torque from your power source (engine, motor, or other). Depending on your power source, you could limit its maximum torque or you could limit the request from the driver using a Saturation block to modify the control signal.
--Steve
0 commentaires
Voir également
Catégories
En savoir plus sur Simscape Driveline dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!