simulink-using threshold
17 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi,
I am trying to simulate a case in simulink where i need to set the output to 1 when the input is between two threshold levels, otherwise the output is 0. I tried to use relay block, but it incorporates hysteresis which i do not want. PLEASE GIVE ME A SOLUTION.
1 commentaire
TAB
le 6 Avr 2012
Is there any problem with using comparator block (<=, >=) along with switch block to implement the logic ?
Réponses (2)
mahjoub el attar
le 5 Avr 2012
The answer is in your question. Don't use Relay block but Threshold Block... Friendly.
2 commentaires
mahjoub el attar
le 5 Avr 2012
I did it before but I just don't remember.I need to check my old models on my own laptop tonight.
I hope you'll get a faster answer.
Voir également
Catégories
En savoir plus sur Subsystems dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!