Question about the "enable" block.
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi,
I have a little question about the enable block. If I have a enable block in a subsystem, what become my outputs when my subsystem is not enable ? And more specially when I have one output which is a bus ?
0 commentaires
Réponse acceptée
Plus de réponses (2)
Arnaud Miege
le 18 Mar 2011
Have a read of Enabled Subsystems in the Simulink documentation, particularly the section Setting Output Values While the Subsystem Is Disabled. As far as I know, this works with busses as well.
HTH,
Arnaud
0 commentaires
Sébastien Malengé
le 18 Mar 2011
2 commentaires
Guy Rouleau
le 22 Mar 2011
Did you really read the section mentioned by Kaustubha? This is what you need. Note that it is available since MATLAB R2010a.
Kaustubha Govind
le 23 Mar 2011
Guy: I think Sebastien's reply was to Arnaud's answer. My answer came later but got voted up, so it shows up higher.
Voir également
Catégories
En savoir plus sur Schedule Model Components dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!