how to send a signal through a usb to a hardware device and make a LED glow
Afficher commentaires plus anciens
how to send a signal through a usb port to a hardware device and make a LED glow
1 commentaire
Daniel Shub
le 30 Avr 2012
How is the LED connected to the usb port?
Réponses (1)
Walter Roberson
le 30 Avr 2012
0 votes
USB is by definition a serial bus; any information sent over the bus is only present on the bus for a small fraction of a second. You thus cannot send and hold a signal via USB. Instead you would have to send data that the destination hardware interpreted as indicating the appropriate LED state.
There are suitable USB-compatible devices available: see http://www.mathworks.com/matlabcentral/answers/18366-how-to-send-a-signal-to-usb
Catégories
En savoir plus sur Troubleshooting in Data Acquisition Toolbox dans Centre d'aide et File Exchange
le 30 Avr 2012
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
