unsolved "initialization commands cannot be evaluated" error when trying to run simulink
4 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am using a R2011b matlab (32bits) which has a simulink demo "six-phase synchronous machine with pose-fault operating strategy". The six-phase syn motor is running fine with the mechanical power Pm as the mechanical input. However, whenever I switch the input to speed w, an initialization error prompts as:
Error due to multiple causes. --> Error in "Power 6phsyncmachine/Six Phase Synchronou Machine 240V 100KVA": Initialization commands cannot
be evaluated. --> Block choice 'Continuous' is not a valid member of 'Power 6phsyncmachine/Six Phase Synchronous Machine 240 100KVA/Mechanical model'
which is the cause?
Thank you!
Thank you!
1 commentaire
Réponses (1)
Joel Van Sickel
le 18 Août 2021
This appears to have been a bug in the library that has been resolved.
0 commentaires
Voir également
Catégories
En savoir plus sur Magnetic Elements dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!